Energy Chain
Installation Instructions
|
 |
The
Extendo Bed will be shipped with the lead end connector
of the Energy Chain already attached to the underside of
the cargo platform. After the Extendo Bed has been installed
in the vehicle, extend the bed fully from the vehicle.
Attach the chain to the connector. |
 |
Lay
the un-anchored end of the chain in the vehicle. |
 |
Allow
the chain to make a "loose" 180 degree arc back into the
vehicle. |
 |
Fasten
end of chain to vehicle floor, using the self-tapping screws. |
 |
Install
the wiring in the chain by pushing the wire/cable thru
the tabs.
NOTE: Wire can also be run in the chain before fastening the chain to the Extendo
Bed or the vehicle. |
 |
Rout
the ends of the wiring to the Extendo Bed and to the vehicle. |
 |
This
shows a completed installation. |
